HOME > PRODUCTS > TRADITIONAL > ARROW COMPONENTS > TRADITIONAL ADHESIVES
- FERR-L-TITE®
- Application
- Shaft Type
- Clamp Time
- Cure Time
- FERR-L-TITE®
- Points, inserts and outserts.
- Cedar, Aluminum
- N/A
- Approximately 5 min.
- FERR-L-TITE® COOLFLEX™
- Points, inserts, pin bushings and outserts.
- Cedar, Aluminum and Fiberglass
- N/A
- Approximately 5 min.
- INSERT IRON™
- Points, inserts, and outserts.
- Cedar, Aluminum, Carbon and Fiberglass
- N/A
- 48 hours
- FLETCH-TITE PLATINUM®
- Vanes, feathers and tapered nocks
- Cedar, Aluminum, Carbon, Wraps and Fiberglass
- 5 Minutes
- 24 hours, but 48 hours is best.
- FLETCH FUSE
- Vanes, points, inserts, outserts and swedged nocks
- Cedar, Aluminum, Carbon, Wraps and Fiberglass
- 30 Seconds
- 2 hours
- BLAZER® BOND
- Vanes, points, inserts, outserts and swedged nocks
- Cedar, Aluminum, Carbon, Wraps and Fiberglass
- 20 Seconds
- 2 hours
Fletch-Tite™ Platinum
Formulated to work with specifically with Fletch-Tite Platinum® Adhesive. Do not use with any other products. Do not over-thin adhesive as this will cause problems with adhesion. Never exceed 2% by volume.
Available in Pints. For more volume options please call or email.
For Ground shipment only.
Ferr-L-Tite®
Ferr-L-Tite was Bohning’s first product, developed in 1946, and has been the archery industry’s standard ever since! This hot melt adhesive is designed for points, inserts, and outserts on wood and aluminum shafts (for carbon, we recommend Ferr-L-Tite Cool Flex). It requires an open flame for installation or removal and is fully cured as soon as it reaches room temperature (about 5 minutes). Ferr-L-Tite is heat reversible on aluminum shafts – flame required. It has a melting point of 350° F (176.7°C).
Available in 12 gram sticks and 1 pound bricks. No expiration.
Proudly manufactured at the Bohning factory in Lake City, Michigan, United States.
Fletching Tape®
Bohning’s double-sided Premium Fletching Tape creates a strong, reliable bond on contact.
It is designed for feathers and for mylar vanes and works on all shaft types – carbon, aluminum, fiberglass, wood, and wrapped or crested arrows. Premium Fletching Tape is machine cut without lubricant, so there are no dead zones in the roll. One roll fletches approximately 40 arrows.
Length of tape: 60 feet (18.3m)
Width of tape – 0.188 inches (4.8mm)
No expiration.
Fletching Tape Dispenser
Easily apply Premium Fletching Tape while keeping it free of dust and debris with Bohning’s Fletching Tape Dispenser. The Fletching Tape Dispenser can be screwed to a work table for added stability. Each Dispenser comes pre-loaded with one roll of Bohning’s Premium Fletching Tape for feathers or mylar vanes.
Proudly manufactured at the Bohning factory in Lake City, Michigan, United States.